41
11. Operation
Combined DMX mode
• Press the button MODE (1) until the display (4) shows “dc”. “dc” means that the device is in combined DMX mode.
• Briefly after this, the display (4) shows the DMX starting address.
• Set the desired starting address with the buttons UP (2) or DOWN (3). The starting address is assumed after approx.
3 seconds and displayed alternatingly with the “dc”.
• Once a DMX signal is received from the connected DMX controller, and LED appears at the right side below the
“d” in the display (4).
• In this operating mode, the effect light covers 4 DMX channels. Their functions are listed below.
• The DMX signals from the controller are output unchanged at the DMX OUT (6) port, so that subsequent effect lights
are controlled synchronously.
DMX channel functions:
DMX channel
DMX values
Spot
Function
CH1
000-255
1/2/3/4
Brightness red
CH2
000-255
1/2/3/4
Brightness green
CH3
000-255
1/2/3/4
Brightness blue
CH4
000-127
1/2/3/4
Overall brightness
128-227
1/2/3/4
Flashing effect, slow > fast
228-255
1/2/3/4
Full brightness, no flashing
f) Display Deactivation
• The display (4) switches off automatically after 25 seconds without any button being pushed.
• Push any button to activate the display (4) again. This button does not trigger any function yet. Only the next button
pushed when the display (4) is lit will be accepted.
g) Key Lock
• Press the button MODE (1) for more than 3 seconds to activate the key lock.
• The display (4) shows “LOC”, alternating with the operating mode set.
• Push the button MODE (1) again for more than 3 seconds to deactivate the key lock again.
