31
7. Installation/Setup
a) Setup with a Stand on the Floor
Adjust the stand height so that the effect light is outside of the area persons reach with their
hands.
The effect light must be sufficiently far from the ceiling or any other limitation areas to prevent
heat accumulation.
The load capacity of the stand must be sufficient for the effect light load.
The stand must have a safety device to prevent inadvertent retraction of the stand.
The stand must be set up on a stable and horizontal surface.
The connection cables must not be located in the public area and the stand must be secured
against tilting (e.g. by pulling at the cables).
The stand’s base must be placed or locked outside of the public area.
The stand must not be placed in the area of escape routes.
• Open the stand clamp screw at the holder.
• Plug the effect light onto a stand with a diameter of 35 mm with the holder. Smaller diameters are not permissible,
because they would prevent secure stand assembly.
• When the holder is entirely plugged onto the stand, tighten the clamp screw.
