33
8. DMX Connection
Pin assignment of the DMX connection: Pin1 = earth / Pin2 = (-) / Pin3 = (+).
Never connect the earth pin GND to the casing earth of the effect light; this may result in interference in
signal transmission caused by ground loops.
b) Setting up a Master Slave Chain
The effect light can be operated controlled by a DMX controller or in a master slave chain. In that case, the integrated
controller of the master device controls the connected slave devices.
• Connect the DMX OUT (5) port of the master device to the DMX IN (6) port of the first slave device.
• Connect the DMX OUT (5) port of the first slave device to the DMX IN (6) port of the subsequent slave device.
• Proceed as described above with all remaining slave devices.
• Plug an XLR plug with a terminating resistor into the DMX OUT (5) port of the last slave device (as described in
section “Connection of a DMX controller”).
9. Commissioning/Replacing the Remote Control Battery
Remove the battery when the device is not in use for extended periods of time.
Leaking or damaged batteries may cause alkali burns if they come in contact with the skin.
Therefore, use suitable protective gloves.
Do not short-circuit the battery and do not throw it into fire. It also must not be recharged. Danger
of explosion.
If required, remove the insulation pad in the battery compartment of the remote control. It protects the
battery from discharge during transport.
• If the remote control no longer functions properly or the range reduces strongly, the battery is discharged and must
be replaced with a new one of the same type.
• Unlock the safety lever and pull the battery holder out at the rear of the remote control.
• Remove the discharged battery and insert a new 3 V-Lithium button cell CR2025. The correct polarity is indicated
in the battery holder.
• Insert the batteries in the remote control again. The safety lever must latch cleanly.
