Mounting Instructions
ProfiDAT
®
Data Transmission System
Programm 0514
MAL0514-0005b-EN
www.conductix.com
translated document
page 44 of 82
6.4.4
Installing the rail connector (without PE)
Fig. 26: Mounting the rail connectors on the ProfiDAT
®
profile
Steps:
Push a rail connector (1) onto the mounted ProfiDAT
®
profile (4) until it reaches the center.
The center of the rail connector is marked with a notch (K).
Fix the rail connector (1) with the two threaded pins (2).
Install all further ProfiDAT
®
profiles (4) in the same way.
Check that all four flange screws (5) are secured by a locking edge washer (6) between the screw head
and rail connector.
Fig. 27: Screw lock with locking edge washer
6.4.5
Installing the Anchor Point
The hanger clamps are designed as sliding suspension devices so that profiles can expand or contract as the temperature changes.
To this end, it is necessary to install defined anchor points and expansion elements (see chapter 6.4.1). The positions of the anchor
points are indicated in the system layout.
The anchor point must be installed before the hanger clamp is fastened to the support structure.
1
5
6
2
4
1
C
5
6
