Mounting Instructions
ProfiDAT
®
Data Transmission System
Programm 0514
MAL0514-0005b-EN
www.conductix.com
translated document
page 42 of 82
Fig. 23: Mounting the ProfiDAT
®
profile on an expansion element
Push the ProfiDAT
®
profile (2) toward the expansion element (7) and insert it into the PE rail connector (8) on the expansion
element until it reaches the center.
CAUTION!
Both profiles must be directly next to one another. The gap must be no more than 0.5 mm wide!
The sliding surfaces for the carbon brushes must be level with one another and deburred.
Secure the PE rail connector (8) to the ProfiDAT
®
profile (2) with the two threaded pins (9).
Tighten the four lateral flange screws (10) on the connector.
Fig. 24: Mounting the rail connectors on the ProfiDAT
®
profile
Push a rail connector (11) onto the mounted ProfiDAT
®
profile (2) until it reaches the center of the connector.
The center of the rail connector is marked with a notch (K).
Fix the rail connector (11) with the two threaded pins (9).
Push the next ProfiDAT
®
profile into the installed connector (11) insert and secure it with the two threaded pins.
Tighten the four lateral flange screws (10) on the connector.
Install all further ProfiDAT
®
profiles in the same way.
7
2
10
9
2
K
9
11
10
8
