Mounting Instructions
ProfiDAT
®
Data Transmission System
Programm 0514
MAL0514-0005b-EN
www.conductix.com
translated document
page 62 of 82
6.5.3
Installing the Connecting Cable (HF cable) on the Infeed Antenna
The connecting cable to the infeed antenna on the ProfiDAT
®
profile is installed between the transceiver in the infeed switching
cabinet and the connection on the infeed antenna.
Work steps:
Push a heat-shrink sleeve onto one end of the connector cable.
Fasten/Screw the straight N plug on the connector cable onto the socket at the power feed cabinet.
Run the connecting cable to the socket of the infeed antenna.
Push a heat-shrink sleeve onto the other end of the connector cable.
Fasten/Screw the angled N plug on the socket of the infeed antenna.
Fasten the cable run to the support structure with cable ties, etc. Stow the excess cable neatly.
CAUTION!
Do not crush the cable!
Comply with the bending radius of the cable.
Push both heat-shrink sleeves over the plugs and socket and shrink them with a heat gun.
6.5.4
Installing the Connection Cable (HS Cable) on the Transceiver
The connecting cables of the antenna on the current collector are installed on the transceiver in the switching cabinet of the mobile
system component.
Also observe the information and safety instructions in the manufacturer's documentation when installing the connecting cables!
Work steps:
Installing the ProfiDAT
®
adapter cable on the transceiver.
Run the connecting cable to the adapter cable.
Connect the connection cable to the ProfiDAT
®
adapter cable.
Secure the cable run with cable ties, etc.
CAUTION!
Do not crush the cable!
Comply with the bending radii of the cables.
Secure the connection point between the connection cable and the ProfiDAT
®
adapter cable (strain relief).
CAUTION!
Avoid tensile stress on the ProfiDAT
®
adapter cable.
Install the second connection cable in the same manner.
