Comtech EF Data CDM-750, Installation And Operation Manual

Page: 96 / 300

CDM-750 Advanced High-Speed Trunking Modem Revision 2
Front Panel Operation MN-CDM750
5–20
5.2.2.1.5 (CONFIG) INTF: Optical
If the CONFIG: Intf menu displays NONE, then the optional Optical Gigabit
Ethernet Interface SFP is either NOT plugged into the J7 | OPTICAL socket, or the
Optical Gigabit Ethernet Interface FAST Access Code is not activated. See Sect.
3.2.3.2 for further information about this optional interface.
5.2.2.2 CONFIG: Tx
Tx: IF Freq Power Frame Mod Data Pilot
Data 130706.252kbps, 030000.000ksps (
)
On the top line, use the
W X
arrow keys to select IF , Freq , Power , Frame , Mod , Dat a, or Pilot ,
and then press ENTER . The read ‐ only bottom line displays the current operating values.
5.2.2.2.1 (CONFIG) Tx: IF
Tx: Carrier=On (Off,On)
SpectrumInvert=Off Tx
α =.35(.35,.25)(
v
)
First, use the
W X
arrow keys to select Tx Carrier , Spectrum Invert , or Tx
α
. On the top line, use
the
ST
arrow keys to set the Tx Carrier as On or Off .
On the bottom line:
•
Use the
ST
arrow keys to set the Spectrum Invert as On or Off .
When the CDM ‐ 750 is in CnC (Carrier ‐ in ‐ Carrier) mode, the modem itself
will determine the Tx spectral inversion. The operator will not have control
of spectral inversion selection while CnC mode is ON and any changes to
this field will be rejected.
•
Use the
ST
arrow keys to set the Tx
α
(Tx Rolloff). Valid selections are .20 (20%), .25
(25%) or .35 (35%) – the default Tx
α
setting is .20 (20%).
Press ENTER when done.
5.2.2.2.2 (CONFIG) Tx: Freq (Frequency)
Tx-IF Frequency: 0050.0000 MHz
(
v
)
To configure the Tx ‐ IF Frequency: First, use the
W X
arrow keys to select a digit to edit, and then use
the
ST
arrow keys to change that digit. Note the following: