Comtech EF Data CDM-625A, Installation And Operation Manual

Page: 247 / 756

CDM-625A Advanced Satellite Modem MN-CDM625A
Ethernet-based Remote Product Management Revision 4
7–17
7.5.4.2.2 Admin | SNMP
•
Chapter 6. FRONT PANEL OPERATION
•
Sect. 7.3 SNMP INTERFACE
The Administrator must use this page to set and return administration information for the
CDM-625A SNMP (Simple Network Management Protocol) feature.
Figure 7-5. Admin | SNMP page
SNMP
• Simple Network Management – Use the drop-down list to select as Disabled or Enabled .
• Enable Authentication Trap – Use the drop-down list to select as Disable or Enable .
•
Assign up to two
SNMP Trap IP Addresses
in the form xxx.xxx.xxx.xxx.
•
Trap Version – Use the drop-down list to select SNMPv1 or SNMPv2 .
•
SNMP Read/Write/Trap Community Strings, SNMP Contact/Name/Location – Create or
edit these alphanumeric text strings as follows:
Setting Factory Default Typical Parameters
SNMP Read Community String public
The Read, Write, and Trap Community Strings
can be any alphanumeric combination with a
maximum length of 4 to 15 characters.
SNMP Write Community String private
SNMP Trap Community String comtech
SNMP Contact N/A
The SNMP Contact, Name, and Location strings
can be any alphanumeric combination with a
maximum length of 0 to 20 characters.
SNMP Name N/A
SNMP Location N/A
•
CDM-625 MIB Compatibility – Use the drop-down list to select as Disabled or Enabled .
This feature is available only when the optional IP Packet Processor is installed and enabled .
When enabled, you may use CDM-625 MIBs to monitor and control features that are
common to both the CDM-625 and CDM-625A/AL modems.