Comtech EF Data CDM-625A, Installation And Operation Manual

Page: 132 / 756

CDM-625A Advanced Satellite Modem MN-CDM625A
Front Panel Operation Revision 4
6–8
6.2.1 SELECT: CONFIG (Configuration) Menu Branch
CONFIG: All Mode Tx Rx Clocks D&I/ACM
CnC EDMAC Misc Mask Remote IP (

)
Use the ◄ ► arrow keys to select a submenu. Press ENTER . Valid selections are:
Submenu Sect. Function
All 6.2.1.1
This submenu is highly recommended for new users, as it leads you through the
complete modem configuration process on a step-by-step basis.
Mode 6.2.1.2 Use to select Frame Type and Data Format for Tx and Rx.
Tx 6.2.1.3
(Transmit) Use to define the Tx configuration of the unit. These menu submenu
branches would be used if you wished to change, for example, just the Tx
Frequency.
Rx 6.2.1.4 (Receive)
Use to define Rx configuration of the unit. These menu submenu
branches would be used if you wished to change, for example, just the Rx data rate.
Clocks 6.2.1.5 Use to select Tx-Clocking, Rx-Buffer/Clock, or External Reference.
D&I 6.2.1.6 Use to select (Quad) Drop & Insert options ( NOT AVAILABLE IN ACM MODE ).
ACM 0
(VersaFEC
®
Adaptive Coding and Modulation) Use to configure ACM operating
parameters. ( AVAILABLE, IN PLACE OF D&I SUBMENU, ONLY IN ACM MODE ).
CnC 0
(DoubleTalk Carrier-in-Carrier) Use to select DoubleTalk Carrier-in-Carrier (CnC)
options.
EDMAC 0 Use to select EDMAC options.
Misc 6.2.1.10 (Miscellaneous) Use to select, view, or change various other parameters.
Mask
6.2.1.10.
9
Use to activate or MASK an alarm condition.
Remote 6.2.1.12
(Remote Control) Use to define whether the unit is being controlled locally,
remotely, or via IP, and to configure the serial Remote Control parameters: baud
rate, I/O format, address.
IP 6.2.1.13
Use to configure various IP parameters, including IP address, gateway, MAC
addresses, VLAN, and QoS.
You may always view the front panel operations and monitor the modem over the
remote control bus (i.e., queries only); however, only one method of remote access
may control the modem at any given time:
• You must be in Local Mode to make configuration parameter changes from the
front panel. Remote Mode is required when using Serial-based remote M&C.
•
You must be in Ethernet Mode when using Ethernet-based remote M&C over IP.