Comtech EF Data CDM-625A, Installation And Operation Manual

Page: 197 / 756

CDM-625A Advanced Satellite Modem MN-CDM625A
Front Panel Operation Revision 4
6–73
Press ENTER .
CONFIG: IP

ANT

PTP: Transport=Unicast
PTP Unicast Master = 192.012.002.021
Sync Rate = 1 Message every 2 seconds
Once you select Unicast , use the ◄ ► arrow keys to navigate between the top and bottom line.
On the top line
–
To edit the PTP Unicast Master IP Address
, use the ◄ ► arrow keys to select a
digit, and then use the ▲▼ arrow keys to change that digit. Press ENTER .
On the bottom line – Use the
▲▼
arrow keys to select the synchronization interval of packets
per second for messages sent from the Master to the Slave. Available selections are:
•
1 message per second
•
1 message every 2 seconds
•
2 messages per second
•
4 messages per second
•
8 messages per second
•
16 messages per second
• 32 messages per second • 64 messages per second
You may use Sync Rate only when the Grandmaster is LAN port and the Transport
Mode is Unicast.
6.2.1.13.5 CONFIG: IP

PortMonitor
Port Monitor: Enabled Source=Port 2
Destination=Port 3 Direction=Both (

)
Port monitoring allows a port’s ingress and/or egress traffic to be mirrored on another port. This
is useful for link monitoring or packet capturing without interrupting live traffic.
Use the ◄ ► arrow keys to move the cursor to the function; then, use the ▲▼ arrow keys to set
the function parameter. Press ENTER .
Valid selections are:
Function Setting
Port Monitor Enabled or Disabled .
Source WAN , Port 1 , Port 2 , Port 3 , or Port 4.
Destination Port 1 , Port 2 , Port 3 , or Port 4. (You may not select the active “Source” Port.)
Direction Ingress , Egress , or Both .