3-44
Removal and Replacement Procedures
Processor and Heatsink
WARNING:
To reduce the risk of personal injury from hot surfaces, allow the
internal system components to cool before touching.
To remove the processor and heatsink:
1.
Perform the service preparations described on page 3-2.
2.
Remove the following components:
❏
workstation cover
❏
I/O bracket assembly (expansion board bracket)
❏
system board with tray
3.
Push in the latches on each side of the processor until you hear two clicks
➊
. This locks
the tabs in the open position. Then slide out the processor
➋
.
1
2
1
Figure 3-43. Removing the processor and heatsink
NOTE
: Your processor may look different from the one shown above.
NOTE
: For clarity, the Secondary Processor Power Module is not shown.
To replace the processor and heatsink and to reassemble the workstation, reverse the above
steps. When replacing the processor, push the processor tabs outward. The tabs will click twice,
locking the processor to the system board with tray.
NOTE
: Install the primary processor and heatsink in the primary processor slot.
IMPORTANT:
Before replacing the I/O bracket assembly, read “Important Guidelines for I/O
Bracket Assembly Replacement” earlier in this chapter.
