5-4
System Security
This will delete the password until you establish a new one through Security Management.
NOTE
: The Setup Password may also be deleted by using the Computer Setup utility. Follow the
“Setup Password” procedure provided earlier in this chapter. Locate the Setup Password option
and follow the instructions to delete the Setup Password. The Setup utility will provide an option
to disable the Setup Password; disabling the Setup Password is the same as deleting it.
See the “National Keyboard Delimiter Characters” section in this chapter for information about
alternate delimiter characters.
Clearing a Setup Password
If you forget the Setup Password, you cannot use the Computer Setup utility to change the
configuration settings. You may view the current settings, but you may not change them unless
you know the Setup Password.
To clear the Setup Password:
1.
Turn off the workstation. Disconnect the power cord from the grounded AC outlet and
from the power connector on the rear of the workstation.
2.
Remove the following components:
❏
workstation cover
❏
I/O bracket assembly (expansion board bracket)
3.
Locate the SW1 switch on the system board with tray.
SW1
on
1 2 3 4 5 6
Figure 5-1. Locating the SW1 switch (switch 1 is shown in the ON position)
