3-20
Removal and Replacement Procedures
Diskette Drive
Before beginning the removal procedure, make sure there is no diskette in the drive.
NOTE
: A standard hard drive in bay 2 can be removed using the same steps used to remove a
diskette drive.
To remove the diskette drive from the drive bay:
1.
Perform the service preparations described on page 3-2.
2.
Remove the following components:
❏
workstation cover
❏
front bezel
❏
I/O bracket assembly (expansion board bracket)
3.
Remove the retaining screws securing the drive cage to the front of the chassis.
NOTE
: Depending on your model, you may have 3 or 4 retaining screws.
4.
Extend the drive cage slightly from the chassis.
NOTE
: It is not necessary to completely remove the drive cage to remove any drives.
Figure 3-20. Extending the drive cage
