Event Log Messages
D–4 DIGITAL PowerStorm 1000 Graphics Subsystem Owner’s Guide
Table D-1 (cont.) Windows NT Event Log Messages
Message
Parameters
Description
Mezzanine Bus
hung.
Dbus Status
Register 0
Dbus Status
Register 1
RC Status
Register
A RC Pick or Pipe Sync interrupt has been
received indicating that rendering is complete,
but the RC mezzanine bus is busy.
Bogus Dbus Status.
Dbus Status
Register 0
Dbus Status
Register 1
Software has determined that the values read
from Dbus status registers 0 and/or 1 are
invalid. The parameter values are the contents
of these registers.
The RC ASIC has
detected an error:
Master.
Dbus Status
Register 0
Dbus Status
Register 1
Last RC
Command (high)
Last RC
Command (low)
The Master RC ASIC has received a bad
command. Parameter values are the contents of
Dbus status registers 0 and 1, and the upper
and lower halves of the bad command.
The RC ASIC has
detected an error:
Slave
Dbus Status
Register 0
Dbus Status
Register 1
Last RC
Command (high)
Last RC
Command (low)
The Slave RC ASIC has received a bad
command. Parameter values are the contents of
Dbus status registers 0 and 1, and the upper
and lower halves of the bad command.
An unexpected RC
interrupt has been
detected.
Dbus Status
Register 0
Dbus Status
Register 1
RC Status
Register
An unexpected interrupt has been received
from an RC ASIC. Parameter values are the
contents of Dbus status registers 0 and 1, and
the contents of the RC status register.
A Packet Controller
error has been
detected.
Dbus Status
Register 0
Dbus Status
Register 1
The Graphics Interface Module has detected a
Packet Controller error. Since the PowerStorm
1000 system does not have a packet controller
this event should never be seen. Parameter
values are the contents of Dbus status registers
0 and 1.
The VDM ASIC has
detected an error.
Dbus Status
Register 0
Dbus Status
Register 1
The VDM ASIC has detected a bad VDM
command. Parameter values are the contents of
Dbus status registers 0 and 1.