INS_CNVETX1_REV– 06/10/13 PAGE 43
INSTALLATION AND OPERATION MANUAL
CNVETX1
TECH SUPPORT: 1.888.678.9427
PTZ Camera Pattern
Set and store patterns of movement (camera pan and tilt settings) for the cameras, then recall
them with the ID spin box list on the graphical user interface preset area shown below.
Figure 38: Pattern Area
The number of patterns allowed varies with the camera protocol selected and camera model.
Refer to Supported PTZ Protocols Parameter Range for the number of patterns allowed per
protocol. The symbol table below describes each of the preset symbols.
Table 11: Pattern Symbols
Symbol
Description
Start define pattern
Finish define pattern
Run pattern once
Run pattern repeatedly
To define a pattern:
1. Select a camera ID.
2. Select the Start define pattern symbol
on the graphical user interface.
3. Use the pan and tilt symbols to define a pattern of movement of the camera.
4. Select the finish define pattern symbol.
5. Select the Run pattern once or Run pattern repeatedly to run the defined pattern.
