Guide:
SYSTIMAX
®
iPatch
®
Panel Manager Guide
2–14
9
Repeat Step 8 until you have indicated the relative position of each row of
iPatch Panel ports on the rack.
The iPatch Manager sounds a confirmation tone and the LED on the last panel
or module turns off.
Note:
If you make a mistake ordering the rows, press Start Over to begin the
process again. Resume with Step 6.
If the iPatch Manager does not sound a confirmation tone to indicate that the
panels have been ordered, see the troubleshooting instructions for
“You attempt to program the order of the panels and modules on a rack and the
iPatch Manager does not sound a confirmation tone.” on page 4–13.
If the iPatch Manager shows the Ready screen with the Alarms softkey before
you have finished ordering the rows, review the alarms list and respond to any
alarms. If you have exceeded the number of panel connections allowed, the
Too Many Panels alarm appears. See the troubleshooting instructions for
“Too Many Panels” on page 4–8.
Task F. Install the Other Equipment in the Racks
Install any other equipment on the racks, such as non-iPatch panels, network
equipment, and patch cord organizers. Follow the instructions provided with the
equipment.
Task G. Cable the iPatch Panels and Other Equipment in the
Equipment Room
Make the cable connections to the back of the iPatch Panels and other equipment
in the equipment room. For instructions for cabling iPatch Panels, see the
installation instructions provided with the panel.
Note:
To make it easier to cable the equipment, you can disconnect the power
adapter plug from the PWR jacks on the back of the iPatch Manager (or Network
Manager module). When you have finished cabling the equipment, be sure to
restore power and to secure the power adapter cord to the display patch cord (or
the patch cord inserted in the Network Manager’s 10/100 Base T jack) using the
strain relief strap.
