ADCP-90-459 • Issue 2 • June 2016
Page 12
© 2016
CommScope
. All Rights Reserved.
4
MOUNTING THE 2RU FMT ON THE RACK
For all mounting configurations, the 2RU FMT uses two mounting brackets, one on either side.
Each bracket has four mounting holes (see
Figure 9
), but only the top and bottom holes are
required. Install the tray using the following procedure:
1. Position the tray on the rack aligning the tray mounting holes with the corresponding holes
in the rack.
2. Using the fastening hardware provided, fasten the tray to the rack using four fasteners of
the required type. Use the top and bottom holes in each bracket. Leave the two middle
holes empty.
Figure 9. 2RU FMT Mounting Holes
5
INSTALLING MICRO-VAMS
Micro-VAM trays are shipped empty. Micro-VAMs if ordered, are packaged separately. To
install a micro-VAM, position it as shown in
Figure 10
and slide it down into the guide.
Note: For mounting hole dimensions, see
Figure 8
.
18546-A
MOUNTING
HOLE
S
(TYPICAL)
NOTE:
U
S
E TOP AND BOTTOM HOLE
S
ON BOTH
S
IDE
S
.
