ADCP-90-459 • Issue 2 • June 2016
Page 27
© 2016
CommScope
. All Rights Reserved.
7.1
Opening the Tray
To open the 2RU FMT tray, slide the release tabs inward with both hands and pull the drawer
straight out as far as it goes. While working in the tray, lock tray in position as shown in
Figure 24
. Press latch down to unlock tray and push closed.
Figure 24. Tray Locked in Open Position
7.2
Sliding Adapter Packs
To access a sliding adapter pack (
Figure 25
):
1. Route the patch cord into the tray as shown in the appropriate diagram in
Section 6
.
Danger: Infrared radiation is invisible and can seriously damage the retina of the eye. Do not
look into the ends of any optical fiber. Do not look directly into the optical adapters of the adapter
packs. Exposure to invisible laser radiation may result. An optical power meter should be used to
verify active fibers. A protective cap or hood MUST be immediately placed over any radiating
adapter or optical fiber connector to avoid the potential of dangerous amounts of radiation
exposure. This practice also prevents dirt particles from entering the adapter or connector.
Caution: Placing a load in excess of 12 pounds (5.4 kg) onto an open tray will result in
misalignment or damage to the tray.
24301-A
LOCK
OPEN
LATCH
PUSH DOWN
TO RELEASE
LOCK
