Page 19 of 54
INSTRUCTION MANUAL
SGTEL-168
TELECOM LINE SURGE GENERATOR
1912 1 E l T o ro R d
●
Si l vera do, Ca lifo rni a 9 26 76
●
(9 49) 459 -96 00
●
co m-p o wer. com
REV070516
4.2.2
Fiber Optic Port
The SGTEL-168 surge generator can optionally be
remotely controlled by a computer via the fiber optic
remote interface, using Com-Power’s
TransWare™
software.
4.2.2.1 Setting up the Remote Interface
As shown in Figure 7, connect the supplied fiber optic cable
into the fiber optic port on the front of the SGTEL-168. Connect
the opposite end of the fiber optic cable into the powered
OTA-232 Optical Transreceiver Adapter. Finally, connect the
OTA-232 Adapter to a computer with the Com-Power
TransWare™
software installed.
FIGURE 7 -
Remote Interface Setup Example
Once connection has been made between the computer and
the SGTEL-168, the following message will appear on the front
panel display of the generator:
D E V I C E U N D E R
R E M O T E A C C E S S
If the
TransWare™
software is closed, or the link is broken, the
following message will be will appear on the front panel display
of the generator:
B A C K
T O
L O C A L
C O N
T R O
L
- O K
Refer to section 7 for instructions for controlling the SGTEL-168
Surge Generator via the
TransWare™
software.