Columbus Travel 600, Operating Manual

Page: 8 / 28

travel 600
8

In the section of the landing the machine has to be held by the fixing brake of the the guiding
wheel.

Spilled cleaning liquid should be removed immediately in an appropriate way.

Watch both the travelator/escalator and the machine closely
– in case of sudden changes stop
using the travel 600 immediately and contact authorized personnel.

Switch off the machine with the key of the key switch if the machine stays unattended. Take pre-
cautions against unauthorized use.
1.9 Safety Devices
Check all safety devices daily or before starting to use the travel 600. Among the safety devices are:
1.9.1 The fixing brake of the guiding wheel
Check the fixing brake of the guiding wheel (10) for wear and tear and faultless functioning. In the case of
too much wear and tear or not sufficient functioning the machine may not be further operated. The fixing
brake prevents the travel 600 from rolling.
1.9.2 The EMERGENCY SWITCH-OFF
Check the EMERGENCY SWITH-OFF function daily before beginning to work and after every action on
the machine.
The following procedure has to be followed:

Connect to electric power with cable of travel 600

Put key of key switch into position 1

Press button Start (1) green lamp on

Press EMERGENCY SWITH-OFF, the green lamp goes out

After successful function test the EMERGENCY SWITH-OFF can be unlocked again
1.10 Safety Instructions for Mains operated Machines
It is important that the cable is not damaged by squeezing, tearing, friction or running over with the ma-
chine. The cable has to be checked regularly for damages, i.e. sections where the cable is blank, kinked
or scorched. If the cable is not free from damage (e.g. damage of the protective covering) the machine
must not be used. Before cleaning or service on the machine or when accessories are replaced the cable
has always to be unplugged!
When changing parts such as brushes, vacuuming cylinders, sprayers, cable, plug etc. the regulations
given by the manufacturer have to be observed and original spare parts used. Otherwise the safety of the
machine could be affected. Damages on the main cable may be replaced by a repair center named by the
manufacturer.
10
11
(10) Fixing brake
(11) Guiding wheel