43
The oil is added by removing the cap marked with
the word “OIL” (Fig. 58).
The quantity of oil to be poured in is 1.5 lt. and
the level should be checked with the machine
turned off, bearing in mind that an excess amount
of oil may cause infiltrations in the cylinders and
a deposit on the valves. On the contrary, if the oil
level is too low, the tang of the connecting rod is
prevented from providing the correct lubrication
with the possibility of causing a seizure of the
cylinders.
To check the amount of oil added, see the next
paragraph.
When the operation has been completed, screw
the cap up again.
58
Start and stop
MODELS WITH INTERNAL CONBUSTION ENGINES
For models run by internal combustion engines, the level of the engine oil must be checked.
NOTE
If the engine is run with an insufficient level of oil, it may be irreparably damaged.
Check the oil level on a flat surface with the engine off.
Remove the oil cap and clean the dipstick
(Fig. 59).
Insert the dipstick in the oil refill hole without
screwing it down.
Remove the dipstick and check the level
(Fig. 60).
59
60
Summary of Contents for MCH 13/DH
