COBHAM SEA TEL 9711IMA-70, Installation Manual

Page: 65 / 178

9711IMA-70 Configuring The Satellite Modem Interface.
9-1
9. Configuring The Satellite Modem Interface.
The configuration setup of an integrated satellite modem to the MXP is accomplished via the Communication Interface
Page (Configuration>Interfaces link on the navigational panel on the left hand side of the screen). In order to access this
page, the user must be logged in as either “Dealer” or “SysAdmin”. The current software load, IMA Ver 105 at the time of
this release) contains 6 commonly used satellite Modems (iDirect, Comtech, Gilat, Hughes, STM, and Viasat) as selectable
presets and is typically a prompted selection when using the new Commissioning Wizard. However, the MXP allows
configuration of a “Custom” modem type. The primary focus of this procedure is to define all of the parameter options
made available to allow the commissioning technician to properly integrate any compatible L-Band Satellite modem.
9.1. Satellite Modem Interface
1. If not already, log into the system using the
“Dealer” or “SysAdmin” credentials.
2. On the left hand side of the screen, under
Configuration, select the “Interfaces” link.
3. On the right side of the screen, approximately
half way down is the “Modem Lock Mute”
section. This section is where the user, via
drop down menu selection and/or mutually
exclusive radio buttons, defines:
•
Reflector
•
Modem Type
•
Modem I/O
•
Lock Input
•
Block Output
EAR Controlled - ECCN EAR99