COBHAM SEA TEL 9711IMA-70, Installation Manual

Page: 25 / 178

9711IMA-70 Installation
3-5
3.4. Unpacking the Base Frame and Reflector Crate
The Base Frame and Reflector now share the same crate. The Base Frame is on the lower deck under the Reflector
support structure. The Base Frame, Legs, Feet, Supports and Hardware Kit are located on this crate. The Reflector,
the Boxes containing the Feed & LNB Assembly (Assemblies if two), along with the Feed Struts and Hardware Kit
are located in this crate. If there are two Feed & LNB units they will each be in separate boxes.
Unpacking the Base Fame and Reflector:
1. Open the crate, to expose the contents, as
described above.
2. Remove the lower lag bolts from the “L”
brackets (left and right) that hold the
reflector support structure legs to the crate.
Note: There is one “L” bracket on each side. Only
remove the lower lag bolt from the “L” brackets.
3. Lift the reflector support structure up about
2 feet.
CAUTION:
Be careful not to lift the supports to
more than the necessary height as this could cause
the reflector to flip over.
4. Allow the drop down legs on the reflector
support to swing down to support the
structure in the raised position.
EAR Controlled - ECCN EAR99