Cloos QINEO, Operating Instructions Manual, Page: 171 / 186

171
Depending on the application, the following menu items must be consid-
ered in the "Config" --> "General" --> "Basic settings" menu, see figure.
External process selection
Name Function
"Off"
• If two different processes are executed at the same
time with a Tandem torch.
• If variants of synergy characteristic curves are used.
• If a correction value for Up-Slope or Down-Slope
was set and the robot changes the process during
operation. The correction value is also taken over
for the following process! If you do not want this be-
haviour, we recommend to change the process via a
job change.
"On" • If the robot shall pre-set the welding process.
Number of control voltages
Name Function
"0"
• If the robot shall only set the job number, but no
other parameters.
"2"
• If the robot shall set the two parameters “Arc
length” and “Power”.
"3"
• If the robot shall set the three parameters “Arc
length”, “Power” and “Dynamics”.
When Tandem welding with pulsed arc processes, the pulses can be syn-
chronised differently, see chapter “4. Pulse synchronisation” on page 178.
A welding power source supports up to four wire drive units. Thus different
welding torches and/or welding wires can be used for a Tandem process.
Display Konfig, Grundeinstellung ab V.12
Puls 4 -Takt
V
0
A 1.2 mm Fe
82% Argon 18% Co
2
0.0
Konfig - Grundeinstellungen
Externe Ansteuerung
Anzahl Leitspannungen 3
Ext. Verfahrensanwahl Aus
Qirox Parameter Ein
Start-/Endprogramm im 2 Takt
Start-/Endeprogramm Aus
Feinabgleich-Variante
Feinabgleich über Kennlinie
/- Anschluss
+/- Anschluss Standard
Tandem
Auf
Werksein-
stellungen
zurück