Cloos QINEO, Operating Instructions Manual, Page: 149 / 186

149
No.
Error message on the
display
Possible cause Remedy
28
Error charging circuit on
Tronic Pulse
Check cable connection between
charging circuit and control
computer.
 Service
29
Calibration error
Inverter
Zero point adjustment cannot be
executed. Values too high. Internal
check failed.
 Switch machine Off and On

Service
30 Excess temperature fan
Ambient temperature too high or
fan faulty.

Check air passage and if necessary check
filter mat
 Service
31
Excess temperature
transformer
Ambient temperature too high in
connection with too high welding
capacity or faulty transformer.
 Check air passage and if necessary check
filter mat
 Service
32
Excess temperature
rectifier
Ambient temperature too high in
connection with too high welding
capacity or faulty rectifier.
 Check air passage and if necessary check
filter mat
 Service
33
Excess temperature
power unit
Ambient temperature too high in
connection with too high welding
capacity or faulty power supply
unit.

Check air passage and if necessary check
filter mat
 Service
34
Excess temperature
water pump
Ambient temperature too high
or pump runs without coolant
or coolant circuit is interrupted,
possibly pump faulty.
 Let the machine cool down
 Check cooling circuit
 Refill coolant

Service
35 Overcurrent inverter
Mains current consumption
exceeded.

Switch machine Off and On
 Service
36
Wrong input voltage
from inverter Mains voltage monitoring exceeded.
Mains voltage fluctuations.
 Check mains voltage

Service
37
Duty cycle exceeded
(inverter)
The output currents listed in the
technical data or on the type plate
were exceeded.
 Weld with lower current at the same
duty cycle
 Weld with the same current at a lower
duty cycle
38 General inverter error Hardware error.

Service
39
Robot software version
out-of-date
Software update required.
 Software update
 Service
40
Power unit supply
voltage too low
Hardware error. 
Service
41
Software version remote
control out-of-date
Software update required.
 Software update
 Service
42
Software version SD
module out-of-date
Software update required.
 Software update
 Service
43 SD module failed
Connection is interrupted or SD
module faulty.
Possibly software version SD
module out-of-date.
 Switch machine Off and On
 Check plug and connections
 Software update

Service