Climax FF5300, Operating Manual

Page: 42 / 86

Page 30 FF5300 Operating Manual
Do the following to install the
machining arm:
1. Lift the handle and the con-
trol end of the machining
arm and set it into the lower
dovetail clamp plate (see
Figure 3-9).
NOTICE
Slide the gear interface plate
so the gearing meshes with
the feed gear in the
machine. Rotating the feed
selector knob slightly may
help with meshing the gears.
2. Rotate the arm on the lower
dovetail clamp plate, checking that the feed gears properly engage. Loosely
secure the top dovetail clamp plates so that the arm is retained against the
body.
3. Slide the arm to the desired
location and tighten the M8
clamp screws on the top
dovetail clamp plate until
the arm is secured (see Fig-
ure 3-10).
WARNING
Failure to secure the
machining arm could result
in the arm coming loose
from the machine and
swinging or falling, causing
personnel injury or damage.
3.9 I
NSTALLING THE COUNTERWEIGHT ARM
Do the following to install the counterweight arm:
1. Lift and place the counterweight arm in the mounting position on the main
body.
F
IGURE
3-9. I
NSTALLING THE MACHINING ARM
F
IGURE
3-10. S
LIDING THE MACHINING ARM INTO PLACE