Climax FF5300, Operating Manual

Page: 40 / 86

Page 28 FF5300 Operating Manual
3.6 I
NSTALLING THE
ID
CHUCK
Do the following to install the ID chuck:
1. Adjust the jacking screws to be approximately 0.2" (5 mm) smaller than
the ID dimension. All the jacking screws should be equally extended.
2. Place the chuck into the flange and extend the jacking screws equally to
clamp to the bore ID.
T
IP
:
The standard ID chuck foot swivel gripper allows a maximum of 6° of
taper on the mounting surface.
3. Tighten the jacking screws to a minimum of 20 ft-lbs (27 Nm) to retain the
chuck.
WARNING
Failure to check that the chuck is secure could result in the machine
falling out of or into the workpiece, causing personnel injury or damage.
3.7 I
NSTALLING THE MACHINE TO THE CHUCK
Do the following to install the
machine to the chuck:
1. If the lifting eye was
removed, re-attach it to the
main body.
2. Lift the machine onto the
chuck, aligning the dowel
pin in the end of the main
machine spindle with one
of the four holes in the
chuck interface plate.
WARNING
The FF5300 is heavy and
can cause personnel injury or damage if dropped. Use supplemental
rigging when mounting the machine, in case it falls out or through the
chucking diameter.
F
IGURE
3-8. C
HUCK CENTERED IN THE FLANGE