Climax FF5300, Operating Manual

Page: 54 / 86

Page 42 FF5300 Operating Manual
7. Check that all the machine parts are secure, including the tool head, tool
bit, chucks, and clamps.
8. Check that the feed direction and rate are set correctly (Section 3.13 on
page 37).
CAUTION
Check the machining arm is securely clamped to the main body and
that it will not hit any obstructions around the workpiece. Check that
there is clearance by manually rotating the machine one full revolution.
9. Check that all the lines, cables, and hoses are properly connected and
secured away from moving parts.
WARNING
Broken air lines can whip around, striking the operator or bystanders.
Always check that the supply lines to the machine are secure and
cannot be hit by moving parts.
10. Check the tool condition and sharpness.
11. Check that the tool head is set at the desired angle and is tight.
12. Check all hand tools are removed from inside the machine and the work
area.
CAUTION
Metal chips and other debris can damage the machine and degrade its
performance. Ensure all metal chips and other debris are removed from
the machine before and after each use.
4.2 M
ACHINING
The machine will rotate clockwise when viewed from above. Follow all normal
flange facer operating procedures and pre-run checks.
See Section 2.2 on page 11 for information on the location and function of the con-
trols. See Section 3.13 on page 37 for information on the feed box.
DANGER
To avoid serious injury to hands or arms, do not reach inside the swing
of the machining arm during operation or while the machine is
energized.