Climax FF5300, Operating Manual

Page: 51 / 86

P/N 91025, Rev. 4 Page 39
3.14 C
ONNECTING THE AIR MOTOR TO THE MAIN BODY
,
THE
PCU,
AND AIR SOURCE
Do the following to connect the air motor to main body, the PCU, and air source:
1. Install the air motor into the main body. Tighten the screws to a minimum
of 20 ft-lbs (27 Nm) to secure the motor.
NOTICE
Check that the worm bore and motor shaft are clean and that the drive
key is in place and aligned with the keyway in the worm.
2. Connect the air hose from
the PCU to the air motor.
3. Connect the PCU to a air
source with 90 psi (6 bar)
pressure using a minimum
1/2" 12-mm air hose.
WARNING
Only install the air motor with
the control handle in an
upright position.
If the control handle is down,
the machining arm or tool holder may strike the operator making the
adjustment. See Figure 3-24.
F
IGURE
3-24. I
NCORRECT
(
LEFT
)
AND CORRECT
(
RIGHT
)
EXAMPLES OF CONTROL HANDLE ORIENTATION
F
IGURE
3-23. A
IR HOSE CONNECTION