Climax FF5300, Operating Manual

Page: 47 / 86

P/N 91025, Rev. 4 Page 35
CAUTION
Do not loosen the tool head
rapidly. Keep your hand on
the tool head for stability.
Quick disengagement of tool
head can cause it to swing
unexpectedly, and may
result in personnel injury or
machine damage.
2. Loosen the tool holder
swivel if necessary to
adjust the tool head angle.
T
IP
:
There are detents located at
0°, 23°, and 45° to assist in
setting the desired angle.
T
IP
:
Note that when the tool slide
is on the outboard side of
the feed pinion, as shown in
Figure 3-19 on page 35, the
feed in the + direction is
down.
When the tool slide is
rotated 180° so it is on the
inboard side of the feed
pinion, then the feed in the –
direction is down.
3. Position the tool head.
F
IGURE
3-18. S
WIVEL HEAD LOCKING SCREW ON THE FRONT
OF THE TOOL POST
F
IGURE
3-19. L
OCATION OF SWIVEL CLAMPING SCREW