LUBRICATION PROCEDURE
Lubricate the following parts every three months to
insure smooth operation and reduce wear.
TRUNNION
HOUSING,
WORM SCREW
AND TILT GEAR
These parts are
accessed through the
top cover of the
console.
Apply grease to gear
teeth. Check for
excessive play and adjust with adjusting screw located
on top of cross bar.
Adjusting
Screw
Worm
Screw and
Tilt
Gear
Cross
Bar
KETTLE
TRUNNIONS
On the left hand side of
the kettle there are two
grease nipples on the
top back portion of the
trunnion housing. On the
right hand side of the
kettle you must remove
the console cover to
access the two grease
nipples.
Trunnion Housing
Grease Nipple
MIXER BRIDGE
HOUSING
There are two grease
nipples on the mixer
bridge swivel housing
which are accessed
by removing the front
and back covers on
the 18" console.
Side View of 18" Console
Grease
Nipples
Front
Cover
Back
Cover
RE-INSTALLING SPEED
CONTROL CABLE
Speed Control Assembly
1.
Turn sprocket of speed control so that wire."
A
"
is fully extended towards shaft "
B
".
2.
Insert end of cable through bracket "
C
".
3.
Insert wire so it protrudes approximately 1/2"
to 5/8" through hole in bolt "
D
". Tighten bolt
and bend end of wire.
4.
Bring pump arm "
E
" up until it hits stop bolt "
F
"
and tighten screw "
C
".
5.
Reassemble unit. Speed control knob will go
on pointing toward minimum setting.
6.
Turn mixer on with speed control set at
minimum setting.
7.
If scraper arm is turning, loosen nut "
G
" and
back stop bolt "
F
" off a few turns. Next loosen
screw "
C
" and slowly pull up cable until
scraper arm stops turning. Retighten screw
"
C
". Gently turn stop bolt "
F
" down until it hits
arm. Lock in place by tightening nut "
G
".
8.
Scraper arm should now go from no rotation to
fast rotation by turning speed control knob.
NOTE:
Mixer may run rough and noisy for one or
two hours if air has become trapped in the line.
C
D
A
B
F
E
G
