Regulatory – Compliance and Agency Approval
This equipment complies with or has obtained Regulatory Agency approval at least against the following
standards:
EMC – Immunity
EN 55024 (1998) + Amendments A1 + A2
Safety
EN 60950 (2000)
UL 60950-1
CSA C22.2 N° 60950-1
Telecom – Analog
TIA-968-A
IC CS-03 Part 1
EMC - Emission
FCC CFR 47 Part 15
EN 55022 (1998) + Amendments A1 + A2
EMC - Immunity
EN 55024 (1998) + Amendments A1 + A2
Safety
EN 60950 (2000)
UL 60950-1
CSA C22.2 N° 60950-1
Telecom - Analog
TIA-968-A
IC CS-03 Part 1
TBR21
Compliance and Regulatory Statements
1. EN55022 and CISPR22 Statement
This is a Class B product.
2. FCC Part 15 Statement
This digital equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instruction manual, may cause harmful interference to radio
communications. However there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the interference
by one or more of the following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and receiver.
•
Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
3. FCC Part 68 Statement
Models E-6000Z-RUMxx
Equipped with the optional Analog card, this equipment complies with Part 68 of the FCC Rules and the
requirement adopted by ACTA of the United States.
On the product nameplate of this equipment (located on the bottom of the equipment) is a label that
contains, among other information, a product identifier in the format US: 2DKOT01BEXT6001.
If requested, this number must be provided to the telephone company.
Connection to the Telephone Line
•
This equipment uses RJ11C jacks for connection to the telephone line. You must, upon, request,
provide the following information to your local telephone company:
USOC Jack type: RJ11C
.
•
This equipment cannot be used on the public coin phone service provided by the telephone company.
Connection to party line service is subject to state tariffs.
•
Your telephone company may discontinue your service if your equipment causes harm to the
telephone network. They will notify you in advance of disconnection, if possible. During notification,
you will be informed of your right to file a complaint to the FCC.
EXTender™ IP6000 Quick Installation Guide
7
