Prerequisites for Installation
You must meet the following requirements before installing the EXTender 6000:
Network Requirements
•
You must install and configure appropriate network terminating devices at both the corporate facility
and the branch office. Both network-terminating devices must be fully functional and both must
support an RS-232, V.35, or RS-530 synchronous, asynchronous or Voice over IP (VOIP) interface.
•
If you use an asynchronous connection, you must install the appropriate ISDN Terminal Adapters
(TAs), from the list below. The TAs must be operational at both the corporate facility and the Branch
Office. This list is complete as of the release date of this document. Refer to the Citel’s Web site:
for the most recent list of recommended ISDN TAs.
Table 1:
ISDN TAs
MFG Model(s)
(see note)
TA’s (for Async)
Motorola Bitsurfr
Pro
Bitsurfr Pro EZ
Adtran
ISU 128 (see note)
ISU 2X64
Express 3000
Express NTU
3Com ISDN
TA
3Com U.S Robotics
*Connect
IQ 400 Series
*Multitech LWAY
Hopper
(Async Only)
--
NA <Manual_SETUP_1>
<Manual_SETUP_2>
Motorola Bitsurfr
Pro
TA’s (for Sync 128k
bonding)
Adtran
ISU 128 (see note)
ISU 2X64
Paradyne Acculink
3165
7110 SNMP
CSU/DSU’s
Adtran TSU
LT
General
DataComm
DeskTop 554A
RAD FCD-1L
ADC Kentrox
DataSmart Max
72761, 78640
Motorola FT100S
Larscom
Orion
56/T1
* European Use
Note: For the Async-RS 232 Dial feature to work properly for these devices, you must set up each device
to accept incoming “AT Commands”. Consult the documentation provided with each device for
proper instructions.
Provide proper wiring with adequate punchdown blocks to connect the Remote Unit to the telephones.
Follow the details in Pin Out Assignments on page 19, and provide an RJ-21 female connector.
EXTender™ IP6000 Quick Installation Guide
12
