Figure 25: Call_Suspend Settings
4. Press
the
È
and
Æ
key to the
Timeout
parameter. This parameter causes the units to go into Call
Suspend mode when no activity occurs for the set Timeout value. Set the value between 15 and 240
minutes.
6. (
RVP_Over_IP Only
) Press the
È
and
Æ
key to the
Minimum Connect Time
parameter Enter a
value, in minutes (0 –240) that the EXTender will be connected to the Gateway before falling into Call
Suspend.
Path:
Remote->Configuration->Connect->RVP_Over_IP->Default_Port
Or for individual ports:
Figure 26: Min Connect Timeout
7. Press
the
È
and
Æ
key to the
Remote Only Wakeup
parameter. If you set this parameter to Yes, you
enable wakeup from Call Suspend on activity at the Branch site only (for example, when a telephone
set goes off-hook or a key is pressed). If you set this parameter to No (disabled), incoming calls can
also cause wakeup from Call Suspend.
8. Press
the
È
and
Æ
key to the
Mode
parameter. This sub-menu sets the Call Suspend mode for each
port. The choices are
Ring, or Lam
p.
Note: Use Ring mode for non-ACD sets, and use “Lamp” for ACD sets
.
9. If you have selected
Lamp
mode for any ports, press the
È
and
Æ
key to the
Indicators
parameter.
This parameter sets the Lamp indicators that you want to monitor on the telephone.
Note: Normally you should select call-appearance Lamps
.
10. If the Remote has ACD sets with Headsets, press the
È
and
Æ
key to the
ACD Tone
parameter.
Enable the ACD Tone for each port that has an ACD telephone with Headset.
11. Press the
Å
key to accept changes and go back to the Configuration Menu.
12. Press the
È
key to the
Save
parameter. Press
Enter
to save changes to the active config (.
rem
) file.
Note: Make sure the “Dial-up” and “Dialback” numbers are programmed.
Procedure for Avaya and Meridian (Gateway Configuration)
There is a problem when the gateway reboots because the remote unit has no way of knowing that the
gateway has lost synchronization. Until the two units re-synchronize, all incoming calls will be ignored. To
EXTender™ IP6000 Quick Installation Guide
44
