![background image](http://html.mh-extra.com/html/cisco/vgd-1t3/vgd-1t3_software-configuration-manual_65018109.webp)
Configuring Voice over IP
Configuring Basic VoIP
99
Cisco VGD 1T3 Voice Gateway Software Configuration Guide
session
Sets session [target | protocol | transport] for this peer.
shutdown
Changes administrator state of this peer to down.
translate-outgoing
Sets translation rule.
Table 6
VoIP Dial-Peer Configuration Commands
Command
Purpose
acc-qos
Sets minimally acceptable quality of service for calls to this peer.
answer-address
Sets call destination number.
application
Sets selected application.
clid_restrict
Restricts display of caller ID.
codec
Sets codec for calls to this peer.
default
Set a command to its defaults.
destination-pattern
Sets full E.164 telephone number.
dtmf-relay
Transports DTMF digits across IP link.
exit
Exits dial-peer configuration mode.
expect-factor
Sets expectation factor for voice quality.
fax
Configures fax service.
fax-relay
Sets fax-relay options.
huntstop
Stops hunting on dial peers.
icpif
Sets calculated planning-impairment factor.
incoming
Sets incoming called number.
information-type
Sets information type for dial peer.
ip
Sets IP packet options.
max-conn
Sets maximum connections per peer; “no” sets to unlimited.
max-redirects
Sets maximum redirects for this peer.
no
Negates a command or sets its defaults.
numbering-type
Sets calling or called party numbering type.
preference
Configures preference order of the peer.
req-qos
Sets required quality of service for calls to this peer.
roaming
Sets use of roaming server.
session
Sets session [target | protocol | transport] for this peer.
settle-call
Sets use of settlement server.
shutdown
Changes admin state of this peer to down (no->up).
snmp
Modifies SNMP voice-peer parameters.
tech-prefix
Sets H.323 gateway technology prefix.
Table 5
POTS Dial-Peer Configuration Commands (continued)
Command
Purpose