Using the Command-Line Interface in Cisco IOS Software
Using the CLI
23
Cisco VGD 1T3 Voice Gateway Software Configuration Guide
Note
Both password commands have numeric keywords that are single integer values. If you choose a number
for the first character of your password followed by a space, the system will read the number as if it were
the numeric keyword and not as part of your password.
When both passwords are set, the enable secret password takes precedence over the enable password.
To remove a password, use the no form of the commands: no enable password or
no enable secret password.
For more information about password recovery procedures for Cisco products, see
http://www.cisco.com/en/US/products/sw/iosswrel/ps1831/
products_tech_note09186a00801746e6.shtml
.
Using the Command History Feature
The CLI command history feature saves the commands you enter during a session in a command history
buffer. The default number of commands saved is 10, but the number is configurable within the range of
0 to 256. This command history feature is particularly useful for recalling long or complex commands.
To change the number of commands saved in the history buffer for a terminal session, issue the
terminal history size command:
Router#
terminal history
size
num
A command history buffer is also available in line configuration mode with the same default and
configuration options. To set the command history buffer size for a terminal session in line configuration
mode, issue the history command:
Router(config-line)#
history
[
size
num
]
To recall commands from the history buffer, use the following methods:
•
Press Ctrl-P or the up arrow key—Recalls commands beginning with the most recent command.
Repeat the key sequence to recall successively older commands.
•
Press Ctrl-N or the down arrow key—Recalls the most recent commands in the history buffer after
they have been recalled using Ctrl-P or the up arrow key. Repeat the key sequence to recall
successively more recent commands.
Note
The arrow keys function only on ANSI-compatible terminals such as the VT100.
•
Issue the show history command in user EXEC or privileged EXEC mode—Lists the most recent
commands that you entered. The number of commands that are displayed is determined by the
setting of the terminal history size and history commands.
The CLI command history feature is enabled by default. To disable this feature for a terminal
session, issue the terminal no history command in user EXEC or privileged EXEC mode or the
no history command in line configuration mode.
