![background image](http://html.mh-extra.com/html/cisco/vgd-1t3/vgd-1t3_software-configuration-manual_65018084.webp)
Configuring and Managing the High-Density Packet Voice Feature Card
Upgrading DSP Firmware on the High-Density Packet Voice Feature Card
74
Cisco VGD 1T3 Voice Gateway Software Configuration Guide
2.
configure terminal
3.
voice dsp slot [/dsp] [slot [/dsp]]
4.
firmware {location flash:filename | upgrade [busyout | reboot]}
5.
exit
6.
end
DETAILED STEPS
Command or Action
Purpose
Step 1
enable
Example:
Router> enable
Enables privileged EXEC mode.
•
Enter your password if prompted.
Step 2
configure terminal
Example:
Router# configure terminal
Enters global configuration mode.
Step 3
voice dsp
slot
[
/
dsp
] [
slot
[
/
dsp
]]
Example:
Router(config)# voice dsp 1/1
Enters config-voicedsp configuration mode and specifies
the slot and DSP location or a range of slots and DSPs.
•
For the slot argument, specify a value from 1 to 7 to
specify the location of the High-Density Packet VFCs.
•
For the dsp argument, specify a value from 1 to 24 to
specify the location of the DSP.
•
To specify a range, enter the first two arguments to
specify the first slot and DSP in the range. The second
two arguments specify the last slot and DSP in the
range.
•
Where slash marks appear in the command syntax, they
are required.
Step 4
firmware
{
location
flash:
filename
|
upgrade
[
busyout
|
reboot
]}
Example:
Router(config-voicedsp)# firmware location
flash:123
Specifies the location and filename of firmware and timing
for the upgrade.
•
flash:—Loads the firmware from the flash NVRAM
located within the router.
•
filename—The firmware filename.
Note
The maximum number of DSPware versions
permitted in flash memory is nine.
•
busyout—Starts the firmware upgrade immediately.
•
reboot—Delays the firmware upgrade until the next
reboot.