D14636.13 Profile C60-C40 and Codec C60-C40 Administrator Guide TC7.0, DECEMBER 2013.
www.cisco.com — Copyright © 2010-2013 Cisco Systems, Inc. All rights reserved.
6
Cisco TelePresence System Codec C40/C60 and Profiles using C40/60
Administrator Guide
What’s new in this version
This section provides an overview of the new and changed
system settings and new features in the TC7.0 software
version.
Software release notes
For a complete overview of new features and changes, we
recommend reading the Software Release Notes (TC7). Go
to:
http://www.cisco.com/c/en/us/support/collaboration-
endpoints/telepresence-integrator-c-series/tsd-products-
Software download
For software download go to:
http://www.cisco.com/cisco/software/navigator.html
New features and improvements
New GUI for Touch 8
A new visual design for the Touch user interface is
introduced.
Serviceability: Network status available for Touch 8
Network status for the Touch device is available from the
Touch interface. This information can be used to verify
that the device has an IP address and that it is receiving
and sending packets to the network. You can also detect
if packets are lost (dropped or in error). This can help
identifying network problems that may cause issues in calls.
IPv6 and dual stack support
IPv6 and dual stack operation are fully supported, also when
using ActiveControl and ICE.
Use the following settings if you want to enable dual stack
operation with IPv6 as the preferred protocol:
Network 1 IPStack: Dual
(enables IPv4 and IPv6 network address (default))
Conference 1 CallProtocolIPStack: Dual
(enables dual stack operation for the call protocols)
SIP PreferredIPMedia: IPv6
(selects which IP version to prefer for media if both
versions are supported on both ends)
SIP PreferredIPSignaling: IPv6
(selects which IP version to prefer for signaling if both
versions are supported on both ends)
Presentation will stop when the presentation source is
disconnected
If a presentation source is disconnected or goes into standby
(e.g. a PC), the presentation will automatically be ended
after 10 seconds. If the source is connected or comes out of
standby within 10 seconds, the presentation will automatically
be resumed.
An input is available for presentation only when a content
source (e.g. a PC) is connected to that input.
Tap the upper left corner to
access the
Settings
menu,
features like
Do not disturb
and
Standby
, and more
(depending on system setup).
Tap the icon to activate
selfview, choose a preset
camera position, and pan/
tilt/zoom the camera.
Password protection of the Touch Administrator menu
You must sign in with the video system’s administrator
password to get access to the Administrator menu on Touch 8.
Support for TMS phone book when provisioned by CUCM
As from TMS (Cisco TelePresence Management Suite)
release 14.4 and TC7.0, endpoints that are provisioned by
CUCM (Cisco Unified Communication Manager) can use the
TMS phone book.
Contents
Introduction
Web interface
System settings
Setting passwords
Appendices
Introduction
