Chapter 4
Configuration Procedures for the Cisco 633
Update the CBOS Prompt
4-8
Cisco 600 Series Installation and Operation Guide
78-11190-01
Step 11
To reboot, enter:
rb
Update the CBOS Prompt
The default Cisco 633 system prompt is
cbos>
. The command prompt is limited
to 8 characters. You can change this prompt to a unique subscriber identifier as
shown in the following example.
Step 1
Log on to CBOS using either the serial or Telnet interfaces.
Step 2
To change the default prompt to 4412883 as the subscriber identifier, enter:
cbos#
set prompt 4412883
4412883#
Step 3
To save your changes, enter:
4412883#
write
Step 4
To exit CBOS, enter:
4412883#
quit
Set Passwords
After you have configured your system, you should pick new passwords for both
the
enable
and
exec modes
. Keep in mind that the
enable
mode provides all the
functionality of a system administrator for the CPE. Examples of good and bad
passwords are:
•
Good Password—77ta99y (Do not use the sample password.)
•
Bad Passwords—Passwords such as your name; or your street address, or
home telephone number are too predictable.
