3-7
Cisco 600 Series Installation and Operation Guide
78-11190-01
Chapter 3
Configuration Procedures for the Cisco 627
Using Telnet
Figure 3-1
Remote System List Box
Step 6
Enter the atm0 IP address of your modem in the
Host Name
box and click
Connect
. The system then initiates a connection session. When connection is
initiated, information similar to the following displays:
User Access Verification
Password:
Note
Press the
Enter
key several times to establish a connection.
Step 7
Provide the logon and password information. After the system authenticates your
password, you have access to the CBOS.
Note
You can log on to the CPE using no password by pressing the
Enter
key at the password prompt. Refer to the “
Set Passwords
” section on
page 3-19 for more information about how to set and change
passwords.
Notice to Windows Users
Windows’ Telnet client does not support NVT (Network Virtual Terminal) or any
extra form of option negotiation. However, if you are going to use the Windows
Telnet client, complete the following steps to set your terminal settings.
