Chapter 3
Configuration Procedures for the Cisco 627
Update the CBOS Prompt
3-18
Cisco 600 Series Installation and Operation Guide
78-11190-01
Interleaved Symbols with CRC Errors: 2
No Cell Delineation Interleaved: 0
Out of Cell Delineation Interleaved: 0
Header Error Check Counter Interleaved:0
Count of Severely Errored Frames: 0
Count of Loss of Signal Frames: 0
Remote Counters:
Interleaved RS Corrected Bytes: 0
Interleaved Symbols with CRC Errors: 0
No Cell Delineation Interleaved: 0
Header Error Check Counter Interleaved:0
Count of Severely Errored Frames: 0
Count of Loss of Signal Frames: 0
Update the CBOS Prompt
The default Cisco 627 system prompt is
cbos#
. The command prompt is limited
to 8 characters. You can change this prompt to a unique subscriber identifier as
shown in the following example.
Step 1
Log on to the CBOS using either the serial or Telnet interfaces. Refer to the
“Using Telnet” section on page 3-6
for more information on how to use Telnet to
log on to the CBOS.
Step 2
To change the default prompt to 4412883 as the subscriber identifier, enter:
cbos#
set prompt 4412883
4412883#
Step 3
To save your changes, enter:
4412883#
write
Step 4
To exit the CBOS, enter:
4412883#
quit
