Chapter 5
Configuration Procedures for the Cisco 67x CPE Devices
Configure the WAN Ports and ATM Virtual Connections
5-14
Cisco 600 Series Installation and Operation Guide
78-11190-01
Step 3
To enable the wan0-0 connection, enter:
set interface wan0-0 enable
Step 4
To begin using this connection with the new settings, enter:
set interface wan0-0 open
Step 5
Repeat steps 2 through 4 for every VPI assignment you want to make.
Step 6
To save the new WAN port configuration, enter:
write
Step 7
To exit CBOS, enter:
quit
Changing VCI Settings
Step 1
To make sure the wan0-0 connection remains closed during configuration, enter:
set interface wan0-0 disable
Step 2
To set the VCI number to 4, enter:
set interface wan0-0 vci 4
Note
If you try to enter the command
set interface wan0-0
on a
connection that is already open, the system prompts you to
close that connection before you change the VCI setting. To
do this, enter the command
set interface wan0-0 close.
Step 3
To enable the wan0-0 connection, enter:
set interface wan0-0 enable
Step 4
To begin using this connection with the new settings, enter:
set interface wan0-0 open
Step 5
Repeat steps 2 through 4 for every VCI assignment you want to make.
