-----
CVM-BDM supply network analyzer
-------- --- Page Nº 15
4.- OPERATION MODE
The instrument has a display with three lines (10 characters every line).
When you switch on the power supply of the CVM-BDM you will see on the display:
After some seconds the instrument is ready to work, showing one of the
possible screens. The display indicates the parameter presently shown.
display
The first display shows the voltage of phase L1 (V1), the voltage of phase L2
(V2) and the voltage of phase L3 (V3).
220 V1
220 V2
220 V3
If you press the "
display
" key, we are now reading the CURRENT values for
each phase (A1, A2, A3). However, this screen can be configured in order to display
other different parameters.
When pressing again the "
display
" key, we will see on display the three
previously programmed parameters. If you press the "
display
" key again you can
see from 1 to 15 screens depending of the previous setup.
Card Circ
xxxxx utor
xxxx yyy
Where:
xxxx = hardware configuration.
yyy = Versión software
