Circutor AFQm Series, Instruction Manual

Page: 76 / 108

76
AFQm
Instruction Manual
Table 29 (Cont�): Modbus memory map: Filter parameters (Table 1)�
Parameter Address Units
Phase L3 - L1 voltage E0 V with 1 decimal
Positive DC bus voltage E1 V with 1 decimal
Negative DC bus voltage E2 V with 1 decimal
(1)
For a system with devices in parallel, the parameter value is that of the device connected with RS-485.
(2)
Parameters only accessible for the 60A model.
Table 30:Modbus memory map: Filter parameters (Table 2)�
Parameter L1 L2 L3 LN Units
Current in the filter A3 - A2 A5 - A4 A7 - A6 A9 - A8 [Hi] + [Low] A with 1 decimal
Phase – neutral voltage AA AB AC - V with 1 decimal
% of filter power used D8 D9 DA - %
Voltage THD BA BB BC - % with 1 decimal
Table 31:Modbus memory map: Filter parameters (Table 3)�
Parameter Address Description
AFQm serial no.
(3)
2710 - 2711 Hi [10] + Low [11] serial no.
DSP software version 10C -
HMI software version 1C3 -
(3)
For a system with devices in parallel, the parameter value is that of the device connected with RS-485.
8.2.2.4.- AFQm filter messages
Table 32:Modbus memory map: Filter messages (Table 1)�
Parameter Address
Device status
(4)
110
Bit Description Status
0x0001 Stop
1 : ON
0 : OFF
0x0002 Start
0x0004 Reset alarms
(4)
For a system with devices in parallel, the parameter value is that of the device connected with RS-485.
Table 33:Modbus memory map: Filter messages (Table 2)�
Parameter Address
Alarm messages 105 (Hi value), 106 (Low value)
Bit Description
0x00000000 There are no alarms
0x00000002 L1 overcurrent alarm
0x00000004 L2 overcurrent alarm
0x00000008 L3 overcurrent alarm
0x00000010 L1 overvoltage alarm
0x00000020 L2 overvoltage alarm
0x00000040 L3 overvoltage alarm
0x00004000 Temperature IGBT 1 alarm
0x00008000 Temperature Inductor 1 alarm
0x00010000 Initial Conditions Error
0x00020000 Resonance Alarm