CID TRBC162672, Owner'S Manual

Page: 19 / 68

Xtreme Tree Reaper Brush Cutter
May 2022
19
1. Enter operator’s cab and start skid steer loader.
2. Tilt the skid steer loader quick attach coupler slightly down and drive forward to the rear
of the cutter until the top edge of the quick attach coupler connects into the attachment
mounting bracket. See figure 3.2a below.
3. Slightly tilt the skid steer quick attach coupler up until the coupler and mounting bracket
fully engage. See figure 3.2b below.
4. Activate the coupler pin mechanism to lock the pins into the attachment bracket. If your
skid steer does not have this mechanism, shut skid steer engine off and exit the cab.
5. Push the skid steer quick attach locking levers down until you can see the coupler pins
extend into the slots on the attachment bracket.
Refer to your skid steer operator’s manual for specific instructions on how to mount and
dismount your attachment.
General Attachment Method
To avoid serious injury or death, ensure coupler pins fully extend through the
slots on the attachment bracket and that levers are down in the locked position to
prevent cutter from detaching from prime mover.
3.2 How to Mount Brush Cutter
Figure 3.2a - Brush Cutter Mounting Figure 3.2b - Coupler to Bracket