Christie RPMSP-D120U, Setup Manual

Page: 9 / 51

Section 2
Installation & Setup
RPMX-RPMSP-D120U & RPMSP-D275U Setup Guide 2-1
020-100038-02 Rev. 1 (09/08)
Use the information in this section to successfully install and setup your projector. In
general, the following steps must be completed:
Step 1
– Unpack the projector.
Step 2
– Select and modify the projector’s configuration based on the intended
application: lens-vertical (90 degree) or lens-horizontal (0 degree)
projection.
Step 3
– Calculate throw distance. Position and mount the projector.
Step 4
– Connect sources.
Step 5
– Turn the projector ON.
Step 6
– Adjust projection lens to improve image focus.
Step 7
– Adjust image geometry using the 6-axis adjuster.
Step 8
– Adjust software to optimize image on a single screen, or multiple screens.
NOTES: 1)
The illustrations used in this manual are graphical representations only
and may not depict your projector model exactly. 2) If you are installing your
projector in a TotalVIEW
™
50” or 67”cube enclosure, refer to the separate
installation guide provided.
Proper installation of your projector will ensure the quality of your display. Whether
installing your projector permanently or temporarily take the following into account
to get the best possible performance from your projector.
When designing a projection room, various factors need to be considered such as, are
you operating single or multiple units, room size, lighting and audience seating. All
of these factors must be taken into account in order to achieve the best possible
projector output. The most important factor to consider is the human factor –
the
audience . Data gathered by answering questions like, “How far is the audience sitting
from the display?” and “From which angle will the display be viewed?” are important
first questions to ask yourself when deciding where to place the display, or what type
and size of screen to use.
2.1 Overview
2.2 Pre-Installation
Considerations