Section 3: Operation
RPMX-RPMSP-D120U & RPMSP-D275U Setup Guide
3-5
020-100038-02 Rev. 1 (09/08)
Contrast
Press
Contrast
to change the amount of white in your images. Use
keys until
you reach the desired level of contrast—for best results, start low and increase so that
whites remain bright but are not distorted or tinted, and that light areas do not
become white (i.e., “crushed”). Conversely, low contrast causes dim images. See
3.5,
Adjusting the Image (Image Settings
subsection)
.
Brightness
Press
Bright
to increase or decrease the amount of black in the image. Use
keys until you reach the desired level of contrast—for best results, start high and
decrease so that dark areas do not become black (i.e., “crushed”). Conversely, overly
high brightness changes black to dark gray, causing washed-out images. See
3.5,
Adjusting the Image (Image Settings
subsection)
.
Gamma
“Gamma” determines how gray shades are displayed between minimum input (black)
and maximum input (white) for a given amount of signal. The proper setting helps
maintain optimized blacks and whites while ensuring a smooth transition for the “in-
between” values utilized in grays. Unlike brightness and contrast controls, the
overall tone of an image can be lightened or darkened without changing the two
extremes, and your images will be more vibrant yet with good detail in dark areas.
The normal gamma setting of 2.22 is correct for most signals and conditions. If
excess ambient light washes out the image and it becomes difficult or impossible to
see details in dark areas, lower the gamma setting to compensate. This will improve
contrast ratio while maintaining good details for blacks.
Menu
Press
Menu
to enter or exit the projector’s menu system.
OSD (On-screen display)
Press
OSD
followed by
to hide the projector’s menu system during use.
Invisible menus are fully functional, enabling “hidden” access to numbered features
and image adjustments by entering the corresponding sequence of key presses on the
keypad.
To see the menus again, do one of the following:
•
Press
and hold
OSD
for a second
•
Press and release
OSD
followed immediately by
•
Press
OSD
OSD
NOTE:
With OSD “on”, you can still hide error messages and slidebars by
disabling these options in the
Menu Preferences
menu.
PIP (Picture in Picture)
Press to enable and disable Picture-in-Picture. PIP enables you to display two
different images simultaneously – typically a smaller “secondary” image within a
large “primary” background. When a menu control or slidebar is present, press
PIP
to toggle the current function to affect the other image.
Contrast
Bright
Gamma
Menu
OSD
PIP
Summary of Contents for RPMSP-D120U
