Christie RPMSP-D120U, Setup Manual

Page: 15 / 51

Section 2: Installation & Setup
RPMX-RPMSP-D120U & RPMSP-D275U Setup Guide 2-7
020-100038-02 Rev. 1 (09/08)
Figure 2.8. Throw Distance Formula for Lens-Vertical Configuration
Lifting and transporting the projector –
Use the handles in the mounting tray to
transport the projector a short distance. For longer distances, it is recommended you
use a stable cart or ask for someone’s help.
Mounting
Refer to the drawings provided for your specific projector model in Appendix D for
the mounting hole location and other technical information which may be useful
during installation.
When mounting a projector, do the following:
•
Mount the projector to a sturdy, flat surface such as a table or cart that
fits the entire projector.
•
Use all four mounting points to secure the projector to the surface. Refer
to Appendix D .
• Maintain an area of empty space around your projector, called a “stay
out zone”, to allow for proper air circulation and allow enough clearance for
cable connections to the input panel. An insufficient stay out zone area could
cause the projector to overheat during operation and/or place undue stress on
source connections.
Connect sources
All source connections are made to the input panel of the Electronics Module. This is
the stand alone module to the left of the light engine when looking at the projector
from the back.
Each input is clearly labeled for easy identification. Using the appropriate
cable(s), connect your source. Connect RGB and YPbPr sources to
INPUT 1
Step 4
h