Section 2: Installation & Setup
RPMX-RPMSP-D120U & RPMSP-D275U Setup Guide
2-11
020-100038-02 Rev. 1 (09/08)
Adjust software to optimize image
Use the following as a guide to optimally adjust your projector through various
software settings for the first time.
NOTES: 1)
Refer to Section 3 for details on accessing and adjusting individual
settings.
2)
Unless otherwise indicated, instructions apply to all projector models in
stand-alone or multi-projector configurations.
1.
Display an external signal.
2.
Select a lamp operation mode. Perform all setups in the mode you select.
3.
Assign projector ID number(s).
4.
Select
Image Orientation
in the
Configuration
menu and change the
orientation of the displayed image to suit the installation. For example, in
rear screen displays, select “rear” to display the image correctly.
5.
Modify options in
Menu Preference
to suit your display preferences. For
example, select
Language
to change the menu language to any of the
five available languages.
6.
Enable
Broadcast Key
in the
Communications
menu – this enables you
to switch between communicating with one or all projectors.
7.
Select
Auto Setup
to give the projector a change to setup the best
possible settings for the chosen incoming signal.
8.
Verify that
Processing Mode
, in
Image Settings
, is correct for the
selected source.
9.
Change
Resize Presets
if you want the image displayed at any other
resolution other than native.
10.
Adjust
Pixel Phase
and
Pixel Tracking
from the
Size and Position
menu to eliminate any noise from the displayed image.
11.
Adjust
H-Position
and
V-Position
from the
Size and Position
menu to
re-center the image on screen.
12.
Adjust
Size
in
Size and Position
until the image is at the desired width
then adjust
Vertical Stretch
. Adjusting one option may have an affect on
the other, repeat adjustment if necessary. Adjust H-Position and V-
Position again if required to center the image.
13.
Adjust
Color Wheel Delay
.
14.
Perform
Color Temperature
setup.
15.
Adjust
blacklevels
and
input levels
.
16.
Adjust
lamp power
to match lamp brightness of adjacent projectors, if
necessary.
17.
Adjust color primaries, brightness uniformity and edge blending using
the detailed procedure provided in
Section 3 – Matching Colors in
Multiple Projectors
.
Step
8
h
Summary of Contents for RPMSP-D120U
