Christie RPMSP-D120U, Setup Manual

Page: 40 / 51

Section 3: Operation
3-10 RPMX-RPMSP-D120U & RPMSP-D275U Setup Guide
020-100038-02 Rev. 1 (09/08)
Code Description
64 Unrecognized ROM type
65 Write to flash ROM failed
66 General image processor failure
67 Downloaded code will not fit in the ROMs
68 Communication problem with scaler on image processor
COLOR WHEEL
42 Color Wheel Stopped Spinning
BACKPLANE or OPTIONAL INTERFACE MODULE
A0 Unable to program the Option Card
A1 Unable to power the Option Card
A2 Unable to program the Backplane module
A3 Unable to program the Warp Module
NOTES: 1) Clear system errors with Exit Exit . If you encounter a system error, try resetting the projector by powering
it off and on again (wait at least 90 seconds and allow for proper cooling). For detailed information, monitor the RS232 IN
port. For an indication of engine communication failure, send (SST? 1 15) to get report.
2) Contact dealer/factory if error
persists and if a code appears that is not listed.
Error LED Status
Located next to the 2-digit status display is a single LED that will illuminate one of
three colors to convey the current status of the system. A solid red LED indicates a
system error and the corresponding error code will display in the status display. Refer
to the table below for a description of LED variations. Press
Exit
to acknowledge
and clear the error.
Table 3.2. Error LED Status
LED Status Description
z
Solid yellow
Projector powering down/powering up
z
Solid green
Projector powering on/cooling down
z
Solid Red
System error – see corresponding error code on status
display

Flashing yellow
Lamp expired

Flashing green
Keypad command sent - Command received

Flashing red
Key press error - Wrong protocol sent